Table of Contents
Advertisement
5. Choose the solid pattern with the best printing result.
If there are several good solid patterns, choose the middle one.
6. To change the existing print alignment, press the PRINT MODE button until the lights are on that
correspond the best solid pattern in the samples.
7. Press the ON LINE button to print the selected solid pattern.
Make sure this is the best solid pattern.
If not, repeat steps 5 through 7.
8. Press the POWER button to turn off the printer.
Turning off the printer automatically saves the optimized alignment.
1 of 1
Using the Printer With MS-DOS 232
4/15/98 2:19 PM
Advertisement
Table of Contents
