Table of Contents
Advertisement
Paper does not load
into printer.
Multiple sheets load
into printer
Repeated paper jams
occur
Envelopes do not
load
Paper selection lever or paper
support may not be set correctly.
Single sheets may not be feeding
correctly.
Sheets of paper may be sticking
together.
Paper selection lever may not be
set correctly.
Too much paper may be stacked
in sheet feeder.
Different types of paper may be
stacked in sheet feeder.
Paper does not meet printer
specifications.
The paper you are using may be
causing the jams.
Paper selection lever may not be
set correctly.
Envelopes may not be loaded
To resume printing, press ON LINE.
Make sure the paper selection lever and the
paper support are set to the correct positions.
For automatic loading of plain paper or
other types of cut sheet paper
(including transparencies, etc.) set the
paper selection lever to the back and
fully extend the paper support.
For automatic loading of envelopes, set
the paper selection lever to the front
and fully extend the paper support.
For manual loading of paper, set the
paper selection lever to the back and
lower the paper support.
When manually loading paper, be sure to
insert a single sheet of paper all the way into
the sheet feeder. If the paper is not inserted
far enough, the printer cannot load it.
Make sure the paper is not sticking together.
Be sure to fan the stack of per before placing
it in the sheet feeder.
Check that the paper selection lever is back
for automatic loading of paper.
Make sure the stack of paper does not exceed
the paper limit mark on the right side of the
sheet feeder. If necessary, remove a few
sheets from the sheet feeder.
Load just one type of paper.
Make sure you are loading paper that matches
the specifications of this printer. See
Appendix A, Specifications for details.
Fan the paper before stacking it in the sheet
feeder. This keeps the sheets of paper from
sticking together.
Check that the paper you are using and your
printing environment are within specification
of the printer. See Appendix A,
Specifications, for details.
Make sure the paper selection lever is set to
the front position.
Make sure the envelopes are loaded properly.
Advertisement
Table of Contents
