Canon Color imageCLASS MF8450c Basic Operation Manual page 450

Message
Not enough TCP/IP resources.
Wait a moment and perform the
operation again.
Perform the operation again.
Prepare a new toner cartridge.
Preparing...
Press the OK key.
Printer Error
Received in memory.
Remove the jammed paper from
inside the cover of the feeder.
Remove the jammed paper from...
Remove the original from the
feeder.
Remove the paper from the output
tray.
Description
You cannot browse the network due
to a lack of TCP/IP resources. This
may be because documents have
just been continuously sent or are
being continuously sent through FTP
or Windows (SMB).
A transmission error has occurred
because the line condition was poor.
The toner is running low.
The machine is not ready for
scanning.
[Stop] has been pressed while
scanning the document using the
feeder.
Some kind of error has occurred in
the machine.
The machine temporarily received
the data in memory because an error
of some kind has occurred in the
machine. This error message appears
with one of the messages below.
<Load paper.>, <A cover is open.>,
<Check that all of the covers are
closed.>, <The paper has jammed.>,
<Remove the jammed paper
from...>, <Replace the toner.>
An original jam may have occurred in
the feeder.
Paper jams have occurred in the
machine.
The machine cannot scan your
original using the feeder. An original
is placed in the feeder and on the
platen glass.
The paper delivery tray is full of
paper.
Action
Wait for a while, and try browsing again.
Check the line condition, then try again.
Prepare a new toner cartridge.
Wait until the machine is ready.
Press [OK], then set the originals again.
Turn OFF the main power switch, wait
for more than 10 seconds, then turn it
ON again. If the message persists, take
a note of the error code that appears
on the bottom left of the display, turn
OFF the main power switch, disconnect
the power cord, and contact Canon
Customer Care Center.
This error message appears with another
message. When the error is resolved, the
received data will be printed out. For
how to solve the problem, see the action
for the messages displayed with it.
Remove the jammed original.
Follow the procedure on the screen
to remove the jammed paper. (See
"Clearing Jams," on p. 12-2)
Remove the original from the feeder.
Remove the printouts from the paper
delivery tray.
Error Messages
12-27