6
Use [▼], [▲] or
the original size, then press [OK].
To switch to the inch sizes, press the left Any key
to select <A/B Sizes>.
7
Use [▼], [▲] or
the hole punch location, then press [OK].
To enter values in millimeters, press the left Any
key to select <Enter mm>.
(Scroll Wheel) to select
(Scroll Wheel) to select
8
Use [▼], [▲] or
the frame erase width, then press [OK].
–
The default setting is <3/4" (18 mm)>. The
maximum original frame erase width that you
can set is <13/16" (20 mm)>.
–
If you want to change the value, press
(Clear) before entering the new value.
–
If you enter a value outside the setting range, a
message prompting you to enter an
appropriate value appears on the screen.
–
When entering the value in millimeters, you
can also use [▼], [▲],
(numeric keys).
9
Use
–
(numeric keys) to enter the
desired copy quantity (1 to 99).
Erasing Shadows/Lines
(Scroll Wheel) to select
(Scroll Wheel), or
–
4-49