SamplexPower Evolution Series Owner's Manual page 98

SECtION 3 |
i
inFo
Standby Mode may also be used to temporary halt normal operation of the Inverter/
Charger without switching OFF the unit completely.
For the Standby Mode to be switched ON, the EVO
operating in one of the 3 Operating Modes – "Inverting" or "Charging" or "Power Saving"
(See Fig 3.1). When Standby Mode is switched ON, the EVO
inverting or charging / AC pass through will be suspended.
Standby Mode is toggled between ON and OFF conditions as follows:
• By momentary pressing (0.1 sec) of ON/OFF Push Key [2, Fig 2.4(a)], OR
• By momentary pressing (0.1 sec) of ON/OFF Push Button on the front panel of the unit (11,
Fig 2.1 in the Owner's Manual for Evolution
When the EVO is in "Standby Mode", operational status will be displayed as follows:
TM
• on the Remote Control eVo-RC:
- No LED display. Green LED marked "Status" (3, Fig 2.4a) and Red LED marked
"FAULT" (4, Fig 2.4a) will both be off
- The LCD will display
- No buzzer
• on the front panel of eVo
- No LED display. Green LED marked "ON" (12, Fig 2.1 in the Owner's Manual for
Evolution
Owner's Manual for Evolution
- No buzzer
3.5. FAULt CLeARinG
If any fault occurs, the LCD screen will display the Fault Message, Red LED Alarm (Fault) will be lighted.
Remove cause of the fault and the unit will remain in Fault Mode. A short press (0.1 seconds) of the
on/oFF button will clear the Fault Message and the EVO
status (if the fault condition no longer exists). Refer to section 7 on "Fault Messages".
3.6 oPeRAtinG MoDeS AnD DiSPLAY SCReenS
There are 4 Operating Modes for the EVO
Screen at any given time (see Fig 3.1): (i) Standby (ii) Inverting (iii) Charging and (iv) Power Saving.
Each mode has several screens of status information such as Voltage/Current/Power etc. as detailed
at Section 3.6.2 and Fig 3.2. The majority of Mode Screens shown in Fig 3.1 are self explanatory, but
the Charging Mode Status Screens require additional details which are shown at Section 3.6.1.
8 | SAMLEX AMERICA INC.
Operation
STANDbY
bATTERY
:
TM
Series Inverter/Charger ) and Red LED marked "FAULT" (13, Fig 2.1 in the
TM
should be in ON condition and should be
TM
Series Inverter/Charger)
TM
(Fig 3.1)
XX.XXV
Series Inverter/Charger ) will both be OFF.
TM
Inverter/Charger will return to operational
TM
Inverter/Charger that will be displayed on the Remote
TM
will exit its Operating Mode i.e.
TM
APPENDIX A