SamplexPower Evolution Series Owner's Manual page 132

SECtION 5 |
5.4 SAVinG / UPLoADinG PRoGRAMMeD PARAMeteRS
5.4.1 Saving Programmed Parameters
All the programmed parameters can be saved on an SD Card (FAT 16 / FAT 32 Format, up to
16 GB capacity). The parameters will be saved in File named "xxxx_yyy.cfg", where the first
group of 4 digits xxxx is the Model No. e.g. 2212 or 2224 or 3012 or 4024 and the second
group of 3 digits YYY is the Revision No. for that Model e.g. 061.
• For saving, first insert the SD Card in the SD Card Slot.
• Then, go to "Parameter Save" Screen (See Section 4.8 and Table 4.8 – under heading
"PARAMETER SAVE"). Steps are given below:
Up Key x 4
SELECT GROUP
CHARGE CURVE
• Now, select
PARAMETER SAVE
will be seen and then, the screen will revert to
1 = Yes
5.4.2 Uploading Saved Parameters
If there is a "xxxx_yyy.cfg" file in the SD card with stored programmed parameters, then on
inserting the card, the Remote Control will ask to upload the Config File. Press Enter Button
to confirm or Back Button to cancel.
Upload conf?
Yes = Enter Key
Upload conf?
No = Back Key
Upload conf
1 %
42 | SAMLEX AMERICA INC.
SD Card
Enter Key
SELECT GROUP
OTHER FUNCTION
PARAMETER SAVE
0 = No
PARAMETER SAVE
. The parameters will be saved and message
1 = Yes
Saved le end
Upload conf?
Asks to confirm upload.
No = Back Key
Upload conf
Asks to cancel upload.
1 %
Configuration uploading.
Up Key x 10
POWER SAVING
1 = Enable
Press Enter
Key, hold
for 3 to 4 sec
and release
Saved le end
PARAMETER SAVE
Saved le end
PARAMETER SAVE
0 = No
Upload conf
1 %
APPENDIX A
Enter Key
PARAMETER SAVE
0 = No
Up Key
PARAMETER SAVE
1 = Yes
PARAMETER SAVE
0 = No
1 = Yes
.
KEY IN PASSWORD
0000
Password 8052
See Section 4.3.1
ò
PARAMETER SAVE
0 = No
Saved le end