SamplexPower Evolution Series Owner's Manual page 97

SECtION 3 |
3.2 PoWeR on / PoWeR oFF
Power on
To power ON the EVO
around 2 sec until competion of sequence explained below:
POWER ON...
ò
SEARCHING ID...
ID= 1
ò
EVO-XXXXE
INVERTER/CHARGER
Power oFF
Press on/oFF Key and hold for 5 seconds to turn OFF the EVO
POWER OFF...
3.3 DAte AnD tiMe SetUP
Set date and time as per procedure given at Section 4.9: "GROUP 6 PARAMETER SETUP: TIME
SETTING".
3.4 StAnDBY MoDe
When the EVO TMis is in Standby Mode, inverting or charging / AC pass through will be suspended.
This Mode is required to be switched ON manually during firmware uploading procedure for
EVO Inverter/Charger. Firmware upload is carried out through the SD Card slot [9, Fig 1.1(a)].
TM
When firmware uploading procedure is initiated, the user will be prompted to switch ON
Standby Mode – message on the LCD screen will show "Press power key to stop inverter".
Once firmware upload is completed, the EVO
Operation
TM Inverter/Charger, press and hold the on/oFF Key continuously for
When the EVO
pressed and held, the LCD screen shows "POWER ON..." and
the Status LED flashes 3 times. EVO-RC starts to search for the
communication ID of the EVO
to. The LCD screen shows "SEARCHING ID" on the first line and
shows the ID number found on the second line. the on/oFF
Key may be released now (At this point, around 2 sec would
have elapsed from the time the ON/OFF Key is kept pressed
VX.XX
continuously). When the default ID of "1" is found, the display
will then show the EVO
XXXXE and Firmware Version VX.XX.
When EVO
pressed and held for minimum of 5 seconds, the LCD screen
will show "POWER OFF..." and both the Status and Alarm
LEDs will turn ON. Now release the ON/OFF key (Please note
that Power Off sequence will be completed and display
"POWER OFF..." will disappear only when the ON/OFF key
is released).
note: if the eVo
age over 140 ± 10 VAC available at the Grid / Genera-
tor inputs, the Power oFF function is disabled and the
unit will remain in the on condition if the power off
sequence is attempted. the AC input must be removed
before the unit can be powered oFF.
Inverter/Charger is OFF and the on/oFF key is
TM
TM
Inverter/Charger Model No. EVO-
TM
Inverter/Charger is ON and the on/oFF key is
TM
inverter/Charger has AC input volt-
TM
exits the Standby Mode automatically.
TM
APPENDIX A
Inverter/Charger it is attached
Inverter/Charger.
TM
SAMLEX AMERICA INC. | 7