SamplexPower Evolution Series Owner's Manual page 95

SECtION 2 |
4.
Take the other end of remote cable and plug it into the RJ-45 Jack at the back of
the EVO-RC (Fig. 2.3).
5.
Check the remote display to ensure the Power-up self test initiates.
6.
If the self test is successful, secure the EVO-RC to the wall using the four screws. (Fig 2.2)
Flush mounting the EVO-RC on the wall with 4pcs, Φ3mm self-tapping
screws (flat head).
The thickness of the wall/panel board at the place of mounting should
not be more than 13mm to ensure that the RJ-45 jack opening is not
obstructed.
Installation
Fig 2.2 eVo-RC Flush Mounting
Fig 2.3 Wall/Panel thickness
WALL / PANEL BOARD
RJ-45 Jack
APPENDIX A
SAMLEX AMERICA INC. | 5