SamplexPower Evolution Series Owner's Manual page 32

SECTIOn 3 |
3.5 DC SiDe ConneCtionS
5
1. battery Positive (+) Input Connector – M10 x 1.50 Nut & bolt (rED Protection Cover 1(a) is removed)
1a. rED Protection Cover for battery Positive (+) Input Connector
2. battery Negative (-) Input Connector – M10 x 1.50 Nut & bolt (black Protection Cover 1(b) is removed)
2a.black Protection Cover for battery Negative (-) Input Connector
3. External Charger (+) Input Connector – M12 x 0.75 Thumb Nut and bolt
4. External Charger (-) Input Connector - M12 x 0.75 Thumb Nut and bolt
5. DC Side Grounding Connector – Hole Dia 6.5mm for up to 25mm
internally connected to the metal chassis of the unit
6. rJ-45 Jack for battery Temperature Sensor EVO-bCTS
The following DC side connections are required to be made (see fig 3.8):
Deep cycle batteries are connected to the battery input terminals (1) and (2). The terminals
–
are provided with protective covers – rED for Positive and bLACK for Negative. fit these
covers once connections have been made. for details on sizing and charging of batteries,
please refer to Section 1.4 under "General Information-Lead Acid batteries".
Use appropriate external fuse (refer to Table 3.1) within 7" of battery Positive terminal.
–
External charging source, if any, is connected to the connectors (3) and (4) as shown
–
above. the maximum capacity of the external charging source is 50A.
battery Temperature Sensor EVO-bCTS is connected to the rJ-45 Jack (6). See fig 2.5 (a)
–
and 2.5 (b) for details.
32 | SAMLEX AMErICA INC.
Installation
6
Fig 3.8 DC Side Connections
1
(AWG #4). Set Screw M-8. This is
2
3 4
2
1a Red
Protection Covers for Battery Terminals
1b Black