SamplexPower Evolution Series Owner's Manual page 117

SECtION 4 |
4.5 GRoUP 2 PARAMeteR Set UP: inPUt SettinG
Please refer to Parameters under Group 2 at Fig 4.1. Details of Parameter set up are given below:
tABLe 4.5. GRoUP 2 PARAMeteR Set UP: inPUt SettinG
Screen
no. for
Group Parameter
2 (Fig
4.1)
1 DeFAULt FReQ
2 GRiD MAX CURRent
3 Gen MAX CURRent
4 HiGH CUt oFF
5 HiGH ReSet
6 LoW CUt oFF
7 LoW ReSet
DeFAULt FReQ:
Default frequency sets the Inverter frequency, which is also the standard frequency for AC input.
Up Key
SELECT GROUP
CHARGE CURVE
GRiD MAX CURRent / Gen MAX CURRent:
In Charging Mode, the net AC input current from the Grid/Generator is the sum of the AC
side charging current and the pass through load current. Based on the rated capacity of the
Grid Branch Circuit/Generator, the net AC input current will be required to be limited to
prevent overloading of the Grid Branch Circuit/Generator.
EVO Series has a very powerful battery charger that will require a proportionate higher AC
TM
input current from the Grid/Generator. The Grid/Branch Circuit/Generator will also be required
to provide current to the AC loads. The desired maximum value of input current from Grid/
Generator can be programmed (Default is 30A). The EVO
current to support the AC loads on priority and use whatever is extra for charging. This will
prevent overloading of the Grid Branch Circuit/Generator. If the AC input current is over the
setting value by 1A for 5 seconds, the EVO
an error message "Input over current!" on LCD screen. For more details, please refer to
Section 5.2.1 of the Owner's Manual for Evolution
GRiD MAX CURRent:
Up Key
SELECT GROUP
CHARGE CURVE
Parameter Setup
eVo-
2212e
5 – 20A 5 – 25A 5 – 20A 5 – 35A
5 – 20A 5 – 25A 5 – 20A 5 – 35A
Enter Key
SELECT GROUP
INPUT SETTING
Enter Key
SELECT GROUP DEFAUT FREQ
INPUT SETTING
Setting range
eVo- eVo-
3012e 2224e 4024e
0 = 50Hz; 1 = 60Hz
50 – 70Hz
50 – 70Hz
40 – 60Hz
40 – 60Hz
Enter Key
DEFAULT FREQ
0= 60Hz
Inverter/Charger will stop outputting and display
TM
Series Inverter/Charger.
TM
Up Key x 1
GRID MAX CURRENT
0= 60Hz 16.00 A
Default value
eVo- eVo- eVo-
2212e 3012e
KEY IN PASSWORD
0000
Password 8052
See Section 4.3.1
will automatically reduce charging
TM
Enter Key
KEY IN PASSWORD
0000
Password 8052
See Section 4.3.1
SAMLEX AMERICA INC. | 27
APPENDIX A
eVo- eVo-
2224e 4024e
0 = 50Hz
16A
16A
55Hz
54Hz
45Hz
46Hz
DEFAULT FREQ
0= 50Hz
GRID MAX CURRENT
16.00 A