Table of Contents
Advertisement
5522A
Operators Manual
Composite Harmonics Function (Volts)
This section describes the Composite Harmonics Function in the Volts Mode. Amps,
Volt-Volt, and Volt-Amp Modes, have similar menus and operation.
How to Enter the PQ Modes
To gain access to the power quality (PQ) functions, press
More Modes Menu, shown below, appears in the Control Display. Enter the PQ mode by
selecting the desired function, PQ:COMP HARMONIC or PQ: ΔAMPL. The PQ:COMP
HARMONIC mode accesses the Composite Harmonics Function and the PQ: ΔAMPL
mode accesses flicker and sags & swells simulation.
When PQ:COMP HARMONIC or PQ:
Output Display reads "1.0000 V 60Hz" as a default.
How to Create Composite Harmonic Waveforms
Press the PQ:COMP HARMONIC blue softkey. The top-level PQ:COMP HARMONIC
Menu, shown below, appears.
From this menu, composite harmonic waveforms can be created and stored for later use.
7 pre-loaded waveforms may also be recalled from this point. To recall, edit, or create a
composite harmonic wave, press the SET WAVE blue softkey. The Wave Selection
Menu, as it appears in the Control Display, is shown below.
The Wave Selection Menus
From the Wave Selection Menu, the user has four choices:
1. RECALL WAVE
2. SAVE WAVE
3. NEW WAVE
4. EDIT WAVE
A brief explanation of each of these menus follows. More detailed explanations are later
in this section.
11-8
Note
Δ
AMPL mode is selected, the
o n the front panel. The
nn327f.eps
nn333f.eps
nn353f.eps
Advertisement
Table of Contents
