Fluke 522A/6 Operator's Manual page 195

Command
REFCLOCK Sets the reference clock source (internal or through the 10 MHz IN BNC connector).
REFCLOCK? Returns the reference clock source (internal or through the 10 MHz IN BNC connector).
If two Calibrators are synchronized using 10 MHz IN/OUT, sets the phase difference
REFPHASE between the NORMAL terminals on the slave Calibrator and the NORMAL terminals of
the master Calibrator.
If two Calibrators are synchronized using 10 MHz IN/OUT, returns the phase difference
REFPHASE? between the NORMAL terminals on the slave Calibrator and the NORMAL terminals of
the master Calibrator.
STBY Puts the Calibrator in standby.
Sends a synchronization pulse out to a slave Calibrator through the 10 MHZ OUT BNC
SYNCOUT
connector.
WAVE Sets the waveforms for ac outputs.
WAVE? Returns the waveforms of the output.
ZCOMP Activates (2-wire or 4-wire) or deactivates impedance compensation.
ZCOMP? Returns whether or not impedance compensation is active and if active, which type.
Command
DAMPEN Activates or deactivates dampening (averaging) of pressure readings.
DAMPEN? Returns whether dampening (averaging) of pressure readings is active.
PRES? Queries the attached pressure module for its model and serial number.
PRES_MEAS Changes the operating mode to pressure measurement.
Returns the last thermocouple, pressure, or, for the -SC600, impedance measurement
VAL?
value.
Zeros the pressure module or sets the zero offset for capacitance measurement using
ZERO_MEAS
the -SC600.
Returns the zero offset for the pressure module or capacitance measurement using the -
ZERO_MEAS?
SC600.
Command
LOCAL Puts the Calibrator into the local state.
Puts the Calibrator into the lockout state. This command duplicates the IEEE-488 LLO
LOCKOUT
(Local Lockout) message.
Puts the Calibrator into the remote state. This command duplicates the IEEE-488 REN
REMOTE
(Remote Enable) message.
SPLSTR Sets the serial remote mode Serial Poll response string.
Table 6-5. Output Commands (cont.)
Table 6-6. Pressure Measurement Commands
Table 6-7. RS-232 Host Port Commands
Command Summary by Function
Description
Description
Description
6
Remote Commands
6-7