Fluke 522A/6 Operator's Manual page 214

5522A
Operators Manual
*OPC?
(Operations Complete query) Returns a 1 after all pending operations are complete. This
command causes program execution to pause until operations are complete. (See *WAI.)
Response:
Example:
Returns 1 when all pending operations are complete.
OPER
(Operate command) Activates the Calibrator output if it is in standby. This is the same as
pressing the Calibrator front panel O key. If there are errors in the error queue, the
OPER command is inhibited for outputs 33 V and over. (Also see the ERR? command
and STBY command.)
Parameter:
Example:
Connect the selected output to the Calibrator front panel terminals. Also lights the
annunciator in the O key.
OPER?
(Operate query) Returns the operate/standby setting.
Response:
Example:
Returns 1 when the Calibrator is in operate.
*OPT?
(Options command) Returns a list of the installed hardware and software options.
Responses:
Example:
Returns SC600 when the Oscilloscope Calibration Option is installed.
OUT
(Output command) Sets the output of the Calibrator and establishes a new reference
point for the error mode. If only one amplitude is supplied, the Calibrator sources a single
output. If two amplitudes are supplied, the Calibrator sources two outputs. The second
amplitude will be sourced at the AUX terminals for dual voltage outputs. If the frequency
is not supplied, the Calibrator will use the frequency that is presently in use.
To source or measure a temperature, select the desired sensor and sensor parameters first.
(See the TSENS_TYPE, RTD_*, and TC_* commands.)
To source a signal using the Calibrator scope options, refer to the SCOPE command in
Chapter 8.
6-26
x x
IEEE-488 RS-232
(all operations are complete)
1
*OPC? returns 1
x x
IEEE-488 RS-232
(None)
OPER
x x
IEEE-488 RS-232
1 (Operate)
0 (Standby)
OPER? returns 1
x x
IEEE-488 RS-232
<option string>,<option string>,... (options list, separated by commas)
0 (no options are installed)
*OPT? returns SC600
x x
IEEE-488 RS-232
x x
Sequential Overlapped
x x
Sequential Overlapped
x x
Sequential Overlapped
x x
Sequential Overlapped
x x
Sequential Overlapped
x
Coupled
x
Coupled
x
Coupled
x
Coupled
x
Coupled