Table of Contents
Advertisement
5522A
Operators Manual
How to Set DC Current Output
Complete the following procedure to set a dc current output between AUX HI and LO or
AUX 20A and LO, depending on the current level selected. Current greater than ±3 A is
sourced between the AUX 20A and LO terminals. If you make an entry error, press G
to clear the display, then reenter the value.
See Figure 1-4 in Chapter 1 for a chart that shows duration or duty cycle
limitations for current greater than 11 A. If the duration or duty cycle is
exceeded, the Calibrator will shut down abruptly. After a cool-off period,
the Calibrator will work normally.
1. Press R to clear any output from the calibrator.
2. Connect the UUT as described earlier in this chapter under "How to Connect the
3. Set the UUT to measure dc current on the desired range.
4. Press the numeric keys and decimal point key to enter the desired current output
5. Press I to select the polarity of the current (default is +).
6. Press a multiplier key, if necessary. For example, press c.
7. Press A.
8. The Control Display now shows the amplitude of your entry. For example,
9. Press E. The calibrator clears your entry from the Control Display and copies it
10. Press O to activate the calibrator output.
A range softkey appears on the Control Display in the dc current function (operating
range). This selects autorange (auto) or lock (locked) for the present range. When auto
(the default setting) is selected, the calibrator automatically selects the range that
provides the best output resolution. When locked is selected, the calibrator will not
change ranges when you are editing the output. The locked selection is usually made
when you do not want range changes that may cause a small perturbation in the output,
e.g., when checking the linearity of a given multimeter range.
Another softkey appears: OUTPUT. When you select 20 A for this parameter, or you
select a current above 3 A, the calibrator switches to standby, and you must change the
test lead to the 20A terminal and press O to activate the output.
4-22
Calibrator to a UUT."
(maximum six numeric keys). For example, 234.567.
234.567 mA.
into the Output Display (below is typical).
Note
nn077f.eps
nn078f.eps
Advertisement
Table of Contents
