a) Specify minus values to stretch the tiles in the vertical direction.
Specify plus values to stretch the tiles in the horizontal direction.
To mask the Mosaic effect with a selected pattern
Press [Mask] to open the DME >Video Modify >Mask
menu (4127), and set the type of pattern and modifiers (see
page 247).
Sketch Settings
Applying the Sketch effect
1
Open the DME >Enhanced Video Modify >Sketch
menu (4171).
2
Press [Sketch], turning it on.
3
In the <Sketch Mode> group, select the method for
applying outlines.
Sketch: Apply touches like a sketch.
Edge Color Enhance the outlines.
Draw: Apply touches like a line drawing.
Relief: Apply touches like a bas-relief effect.
Sharp: Apply touches that increase the apparent
resolution.
4
Depending on the selection in step 3, set the following
parameters.
When [Sketch] is selected
No.
Parameter Adjustment
1
Mix
Mix level for Sketch effect video
and input video
2
Clip
Reference level for outline
extraction
3
Gain
Gain level for outline extraction
image
4
C Gain
Chrominance gain of input video
When [Edge Color] is selected
No.
Parameter Adjustment
1
Mix
Mix level for Edge Color effect
video and input video
2
Clip
Reference level for outline
extraction
When [Draw] is selected
No.
Parameter Adjustment
1
Mix
Mix level for Draw effect video and
input video
2
Clip
Reference level for outline
extraction
a)
b)
a)
b)
a)
b)
245
No.
Parameter Adjustment
3
Gain
Gain level for outline extraction
image
When [Relief] is selected
No.
Parameter Adjustment
1
Mix
Mix level for Relief effect video and
input video
2
Offset
Relief luminance level
3
Gain
Gain level for outline extraction
image
4
Angle
Direction of relief image light
source
When [Sharp] is selected
No.
Parameter Adjustment
1
H
Simultaneously adjust the left and
right resolution
2
V
Simultaneously adjust the top and
bottom resolution
3
All
Simultaneously adjust the
resolution of all four sides
5
Coring
Minimum value of edge to
emphasize
a) 0.00 is the original input image, and 100.00 gives an image
transformed by the effect.
b) The larger the [Clip] value, the narrower the outline width.
5
If a setting other than [Sharp] is selected in step 3, use
the following procedure as required.
To adjust the outline color for [Edge Color] or
[Draw]
Press [Edge Matte], and set the following parameters.
No.
Parameter Adjustment
1
Luminance Luminance
2
Saturation
Saturation
3
Hue
Hue
To apply color to sections other than the [Draw]
outlines
Press [Matte], and set the following parameters.
No.
Parameter Adjustment
1
Luminance Luminance
2
Saturation
Saturation
3
Hue
Hue
To select the signal to mix with for [Relief]
In the <Chroma Type> group, select the signal to mix
with the relief pattern.
Matte: Select a single color matte. You can adjust the
following parameters.
a)