Sony XKS-C9111 User Manual page 118

When [Utility 1 Bus] is selected: On the cross-point
control block, press delegation button [UTL1] on
the cross-point pad and select a signal using the
cross-point buttons.
Notes
• On the cross-point control block in key/AUX bus
delegation mode, press the [UTIL1] button in the 1st
row and select a signal using the cross-point buttons
in the 2nd row.
• You can assign the utility 1 bus using the [UTIL]
button on the cross-point pad of the cross-point
control block (see page 79).
• You can assign a utility 1 bus delegation button to
the 1st row or 2nd row of the AUX bus control block
(AUX bus operation mode) in the Setup menu (see
page 418).
When [Matte] is selected: Press [Matte Adjust] to
open the Matte Adjust menu (1112.1), and select
[Flat Color] (single color) or [Mix Color] (2-color
mix) in the <Edge Matte> group.
If [Mix Color] is selected, set the color mixing (see
page 119).
If [Flat Color] is selected, adjust color 1 using the
following parameters.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
6
If the edge type is emboss, adjust the color in the
<Emboss Fill> group.
When adjusting color 1 and 2, select [Matte 1] and
[Matte 2], respectively, then adjust the following
parameters.
No. Parameter Adjustment
1 Luminance Luminance
2 Saturation Saturation
3 Hue Hue
7
To soften the edge, select [Soft Edge] and set the
following parameter.
No. Parameter Adjustment
1 Soft Edge softness
Note
When normal is selected for edge type, [Key Drop]
must be enabled beforehand to use [Soft Edge].
8
To make separate fine adjustments to the positions of
the left, right, top, and bottom of the key source, select
[Fine Key] and set the following parameters.
No. Parameter Adjustment
1 Top
2 Left
3 Right
4 Bottom
No. Parameter Adjustment
1 H Phase
2 V Phase
Notes
• When emboss is selected for the edge type, [Fine
Key] cannot be selected.
• When normal, drop border, or shadow is selected for
the edge type, enabling [Fine Key] enables [Key
Drop].
• When applying a border to the key edge, enabling
the [Fine Key] function halves the border width
setting range.
Setting key drop mode
1
In the M/E-1 >Key1 >Edge menu (1112), press [Key
Delay Mode].
The Key Delay Mode menu (1112.4) appears.
2
In the <Key Delay Mode> group, press [Key Drop] to
set key drop mode.
When key drop on mode is set, [Key Drop] is lit.
When key drop off mode is set, [Key Drop] is not lit.
To set the key fill/key source position
Press [8H Mode] to switch between 8H mode and 4H
mode.
When 8H mode is set, [8H Mode] is lit.
When 4H mode is set, [8H Mode] is not lit.
To fix key fill/key source to key drop off mode
Enable frame delay mode.
In the <Key Delay Mode> group, press [Frame Delay],
turning it on.
Notes
• The resizer function is used in frame delay mode. The
frame delay mode setting is enabled only when the
conditions for use of the resizer are satisfied.
118
Parameter group [1/2]
Key top edge position
Key left edge position
Key right edge position
Key bottom edge position
Parameter group [2/2]
Key horizontal position
Key vertical position