Sony XKS-C9111 User Manual page 448

5
Press [Set].
To clear the signal format setting
Press [Clear].
6
Press [Execute].
Setting the format converter conversion
method
You can set the format converter conversion method for
each FC channel.
The conversion method items and the target conversion
formats are given below.
Item Conversion format
Enhancer • 1080P (Level A) t 3840×2160P
(Level A, 2SI)
• 1080P (Level B) t 3840×2160P
(Level A, 2SI)
• 1080i t 3840×2160P (Level A, 2SI)
• 1080P (Level A) t 3840×2160P
(Level A, SQD)
• 1080P (Level B) t 3840×2160P
(Level A, SQD)
• 1080i t 3840×2160P (Level A,
SQD)
• 576i t 1080i
Up-converter
aspect ratio
• 480i t 1080i
• 576i t 720P
• 480i t 720P
Down-converter –
aspect ratio
I/P converter • 1080i t 3840×2160P (Level A, 2SI)
conversion mode
• 1080i t 3840×2160P (Level A,
SQD)
• 1080i t 1080P (Level A)
• 1080i t 720P
Up-converter • 576i t 1080i
conversion mode
• 480i t 1080i
• 576i t 720P
• 480i t 720P
1
In the Engineering Setup >Switcher >Input >Internal
FC menu (7332.5), press [FC Adjust].
The FC Adjust menu (7332.2) appears.
2
Display the target FC channels to set in the status area.
Press [FC 1-4], [FC 5-8], [FC 9-11], or [FC 13-16] to
switch the display in the status area.
3
In the status area, select an FC channel.
4
Set the conversion method.
To configure the enhancer
1
Press [Enhancer], turning it on.
2
Set the following parameters.
No. Parameter Adjustment
2 Detail Gain Adjust the edge enhancement
3 Limiter
4 Crisp
5 Level
Depend
No. Parameter Adjustment
2 Frequency
a) 0 (high frequency) to 2 (low frequency)
To set the up-converter aspect ratio
1
In the <Aspect> group, select one of the following.
Edge Crop: Add black bars on the left and right sides
of a 4:3 aspect ratio image to convert it to a 16:9
image.
Letter Box: Crop the top and bottom of a 4:3 aspect
ratio image to convert it to a 16:9 image.
Squeeze: Stretch a 4:3 image horizontally to covert it
to a 16:9 image.
Original image (4:3)
448
Parameter group [1/2]
sharpness
Adjust the maximum signal level to
be added to the original signal
Set the amplitude value for which
low-amplitude signals are not
enhanced
Set the luminance range for edge
enhancement
Parameter group [2/2]
Set the center frequency for edge
a)
enhancement
Format converted image
(16:9)
Edge Crop
Letter Box
Squeeze