Table of Contents
Advertisement
INITIATING A HARDWARE RESET ON BB-MESP211T
To initiate a Hardware Reset on the Modbus Gateway, press and hold the Mode switch for 0 to 2
seconds, and then release it. The LED indicators respond as follows:
1. The Ready LED blinks while the button is being pressed.
2. When the Modbus Gateway has reset and rebooted into Normal Mode, the Ready LED will
be blinking.
RELOADING FACTORY DEFAULTS
To reload Factory Defaults, press and hold the Mode switch for more than 10 seconds. The LED
indicators respond as follows:
1. The Ready LED blinks three times per second while the button is being pressed.
The Modbus Gateway reloads all factory default configuration parameters. When the device
has reset and rebooted the Ready LED will be blinking.
2. The LEDs go back to their normal states when the device resumes normal operation.
Note: Factory default parameters are listed in Appendix A
Modbus Gateway – BB-MESP211T
42
Advertisement
Table of Contents
