Advertisement
b) Use a straight, (i.e., non-crossover) cable to connect this port to a local hub, switch or
router that has connectivity to the Internet.
c)
The following Ethernet LED behavior represents the network speed for the LAN port on
the ACS6000 control panel:
© 2019 Brivo Systems LLC. All rights reserved.
•
Green LED only – 1000 M
•
Orange LED only – 100 M
•
Green LED + Orange LED – 10 M
NOTE: Since each OSDP reader is on a separate bus on the ACS6000 board, the RS-
485 default address assigned to each reader should not interfere with any other
OSDP readers assigned to the same control panel. However, make certain that the
default OSDP reader address matches the OSDP address used when assigning the
reader in Brivo Onair.
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual
41
Advertisement
