Advertisement
Brivo ACS6000 Installation Manual
Figure 13 - CAN NODE ADDRESS Jumpers
WARNING: CAN BUS Wiring
The CAN NODE ADDRESS jumpers are used to set the address of each board on the
CAN BUS. DO NOT ASSIGN TWO BOARDS THE SAME ADDRESS, OR THE BUS WILL
NOT FUNCTION PROPERLY.
Set these values sequentially, starting with 2 as the first expansion board address;
address 1 is the MAIN BOARD. Record all addresses on the Installation Worksheet.
These jumper settings will map to board numbers when the control panel is
configured via the application.
© 2019 Brivo Systems LLC. All rights reserved.
P-MAN-PUB-ACS6000 Installation Manual
25
Advertisement
