Advertisement
INSTALLATION PROCEDURES
Establish CAN BUS Wiring
1. If there is an expansion board in the control chassis, connect it to the MAIN BOARD.
© 2019 Brivo Systems LLC. All rights reserved.
NOTE: The ACS6000 and ACS6008 chassis include a pre-assembled CAN Bus
connection cable. This cable should be used for connecting panels within the same
chassis. The ACS6000 chassis include a 2-board connection cable, and the ACS6008
includes a 4-board connection cable. The installer must still manually wire
connections between each individual chassis.
NOTE: The AC6000 enclosure CAN Bus cable has three connectors. If connecting an
ACS6000 mainboard to a door/IO board, use the smaller connector at one end of
the cable for the mainboard, and the first middle larger connector for the door/IO
board. If connecting two door/IO boards, use the first and second larger board
connectors. In an ACS6008 enclosure, you have the option to connect a mainboard
to three door/IO boards or to connect four door/IO boards together using the
provided pre-assembled CAN Bus cable. Upon completion, there will be an extra
connector (either a mainboard connector or a door board/IO connector at one end
of the cable assembly). The installer may cut this connector off should they deem it
necessary.
Figure 10 - Connect Expansion Board to MAIN BOARD
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual
22
Advertisement
