Advertisement
Connect the MAIN BOARD and all expansion boards to a power supply board
1. Connect the MAIN BOARD in the control chassis to the power supply board.
2. If there is a DOOR BOARD or an INPUT OUTPUT BOARD in the control chassis, connect that to the
power supply board.
3. If there are expansion chassis, connect each DOOR BOARD and INPUT OUTPUT BOARD to the
power supply board in each chassis.
a) Use the power cable that came with each circuit board kit.
b) The Power connector uses a PC-style 4-wire molded (Molex) connector to deliver +12V,
Ground, Power Detection, and Earth Ground to each board from the power supply.
© 2019 Brivo Systems LLC. All rights reserved.
Figure 3 - Connect MAIN BOARD to Power Supply
Figure 4 - Connect Expansion Board to Power Supply
WARNING: Power Supply
DO NOT USE ANY POWER SUPPLY OTHER THAN THOSE SUPPLIED WITH YOUR
BRIVO PRODUCT.
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual
17
Advertisement
