Advertisement
LEGAL DISCLAIMERS
Federal Communications Commission (FCC) Compliancy
You are cautioned that changes or modifications not expressly approved by the part responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation or when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
Re-orient or relocate the receiving antenna.
•
Increase the distance between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit other than the one to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.
This device may not cause harmful interference and
2.
This device must accept any interference received, including interference that may cause undesired
operation of the device.
FCC RF Radiation Exposure Statement
1.
This transmitter must not be co-located or operate in conjunction with any other antenna or transmitter.
2.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
Underwriter Laboratories (UL) Compliance
The ACS6000 complies with the UL 294 Standard for access control units with the following restrictions:
•
The Ethernet port is for supplemental use only. The unit will continue to operate standalone if the
network connection is interrupted.
•
The monitoring software is not UL evaluated.
Canada-Underwriters Laboratories (C-UL) Compliancy (CSA C22.2 No. 205)
For C-UL Listed applications, the unit shall be installed in accordance with Part 1 of the Canadian Electrical Code.
UL294 Performance Levels
Model Number
Access Control Line
Security Level
Brivo ACS6000 and
Level I
ACS6008
Parts and Service
The ACS6000 control panel contains no user serviceable parts. The lithium battery is not serviceable and is to be
replaced by qualified service technicians only.
© 2019 Brivo Systems LLC. All rights reserved.
Destructive Attack
Endurance Level
Level
Level I
Level IV
2
Brivo ACS6000 Installation Manual
Stand-by Power
Conditions
Level
Level I
N/A
P-MAN-PUB-ACS6000 Installation Manual
Advertisement
