Advertisement
Mount and connect the ACS6000 Wi-Fi antenna (if using Wi-Fi functionality)
1. If you are using the Wi-Fi functionality of the ACS6000 board, please make certain that your SW
7-8 Wi-Fi switch is set to the Enabled position.
2. Included in the shipping contents of the ACS6000 panel is a Wi-Fi antenna cable with one end
being a brass washer/screw connector (which is covered by a removable red protective cover)
and the other end being a silver snap connector.
3. Unscrew the brass washer from the cable and place that end through the top of the chassis. Now
screw the washer back in place on the outside of the chassis, securing the cable to the top of the
chassis.
4. Attach the Wi-Fi antenna (included with the shipping contents) to the connector atop the chassis.
5. Attach the silver end of the Wi-Fi integrated circuit antenna connector located in the upper right
hand corner of the Wi-Fi antenna chip on the ACS6000 MAIN BOARD.
© 2019 Brivo Systems LLC. All rights reserved.
NOTE: Wi-Fi Frequency
Wi-Fi on the ACS6000 panel operates in the 2.4GHz frequency bands.
Figure 23 - ACS6000 Wi-Fi Cable Connection
Figure 24 – Wi-Fi Integrated Circuit Antenna Connector
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual
36
Advertisement
