Advertisement
The ACS6000 control panel Tamper On/Off Toggle in the off position deactivates both optical
and physical tamper switches.
Figure 5 - Tamper Switch and Optical Tamper Sensor Locations
OPTIONAL: Connect the physical tamper switch to the MAIN BOARD and to one board in each
expansion chassis.
1. Connect the physical tamper switch to the MAIN BOARD in the control chassis.
© 2019 Brivo Systems LLC. All rights reserved.
WARNING: Powering Electronic Strikes and Latches
DO NOT POWER ELECTRONIC STRIKES AND LATCHES WITH THE BATTERY (OR
OTHER POWER SOURCE) USED TO POWER THE CONTROL PANEL; DOING SO WILL
CAUSE DAMAGE TO THE BRIVO CONTROL PANEL. USE ONLY A UL LISTED
BURGLAR ALARM OR ACCESS CONTROL SYSTEM TO POWER ELECTRONIC STRIKES
AND LATCHES.
NOTE: If the technician is installing the ACS6000 MAIN BOARD as a retrofit in an
ACS5000 enclosure, there is no optical reflector present. The optical tamper will
not function.
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual
18
Advertisement
