Advertisement
1. Connect the battery wires that come with each circuit board kit to the power supply BATTERY
INPUT terminal block.
a) Connect the black wire to the ground (GND) terminal.
b) Connect the red wire to the +12V terminal.
c)
Make sure the battery wires are segregated at least ¼ inch away from all other
input/output wiring.
© 2019 Brivo Systems LLC. All rights reserved.
NOTE: Power Standby Level 1 for UL listed systems.
Figure 8 - Connect Battery Leads to Power Supply
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual
20
Advertisement
