Advertisement
d) If there are expansion chassis, install the appropriate DOOR BOARDs and/or INPUT
OUTPUT BOARDs in each chassis at this time, using the procedures described for the
MAIN BOARD.
e) You will note that the control panel kit contained an adhesive Identity Label. This label
should be affixed to the inside of the front door of the control chassis, beneath the large
wiring guide.
6. Verify presence of optical tamper reflector on the inside of the chassis door.
7. OPTIONAL: Install the physical tamper switch in the chassis.
a)
Install the tamper switch in the chassis by removing the hex collar, seating the switch
inside the provided mounting bracket, and reattaching and tightening the hex collar.
© 2019 Brivo Systems LLC. All rights reserved.
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual
14
Advertisement
