Table of Contents
Advertisement
RIGOL
Chapter 13 Signal Source
Parameter Setting Method
The following two methods are available for setting the basic parameters (such as
the frequency, amplitude, start phase and offset) of MSO2000A/DS2000A series
oscilloscope.
Method 1:
Rotate
or the inner knob of the navigation knob to adjust the parameter at a
relatively smaller step or turn the outer knob of the navigation knob to adjust
parameter at a relatively larger step.
Method 2:
Press down
and the numeric keyboard is displayed, as is shown below. Rotate
the knob to select the desired value and unit and then press down the knob to input
the value and unit.
Figure 13-1 Numeric Keyboard
Note:
The number input cannot exceed 10 digits. Otherwise, "DEL" will be selected
automatically and pressing the knob will execute the delete operation.
13-2
MSO2000A/DS2000A User Guide
Advertisement
Table of Contents
