Rigol 2000 Series User Manual page 54

RIGOL
14. CH2 Vertical Scale
Display the on/off status of CH2 and the voltage value per grid of CH2 waveform
vertically. In addition, the following labels will be displayed according to the
current channel setting: channel coupling (e.g.
and bandwidth limit (e.g.
parameter.
15. Digital Channel Status Area
Display the current status of the 16 digital channels (D0 to D15 from right to
left). The digital channels currently turned on are displayed in green, the digital
channel currently selected is displayed in red and the digital channels currently
turned off are displayed in grey.
Note: This function is only applicable to MSO2000A and MSO2000A-S.
16. Message Box
Display the prompt messages.
17. Source1 Waveform
Display the type of the waveform currently selected by Source1.
When the impedance of the signal source is set to 50 Ω,

displayed at the right of the Source1 waveform.
When the modulation is enabled,

Source1 waveform.
Note:
This function is only applicable to MSO2000A-S.
18. Source2 Waveform
Display the type of the waveform currently selected by Source2.
When the impedance of the signal source is set to 50 Ω,

displayed at the right of the Source2 waveform.
When the modulation is enabled,

Source2 waveform.
Note:
This function is only applicable to MSO2000A-S.
19. Notification Area
Display the system time, sound icon, USB storage device icon and PictBridge
printer icon.
System Time

1-24
). You can use VIRTICAL
will be displayed at the right of the
will be displayed at the right of the
Chapter 1 Quick Start
), input impedance (e.g.
SCALE to modify this
will be
will be
MSO2000A/DS2000A User Guide
)