Waveform Recording - Rigol 2000 Series User Manual

RIGOL

Waveform Recording

When the waveform recording function is turned on, waveforms from all the
channels currently turned on will be recorded. Press Utility  Record  Mode
and use to select "Record" to open the waveform record operation menu.
1. End Frame
Press End Frame; use
the the desired number of frames to be recorded at a relatively smaller step or
turn the outer knob of the navigation knob to adjust the the desired number of
frames to be recorded at a relatively larger step. The available range is from 1 to
the maximum number of frames that can be recorded currently (displayed in
Total Frames).
2. Record Operation
Waveform recording can be realized via the menu or the shortcut buttons on
the front panel.
Menu
Press Operate and select "●" to
start recoding.
When the record is finished, "●"
changes to "■" automatically.
You can also select "■" manually
to stop recording.
3. Interval
Press Interval; use
time interval at a relatively smaller step or turn the outer knob of the navigation
knob to adjust the time interval at a relatively larger step. The range available is
from 100 ns to 10 s.
4. Total Frames
The menu shows the maximum number of frames that can be recorded
currently.
The number of points of each frame is the current memory depth
11-2
or the inner knob of the navigation knob to adjust
Front Panel
Press
and starts to flash, indicating that the
record is started.
When the record is finished,
automatically and
orange). You can also press
stop recording.
or the inner knob of the navigation knob to adjust the
Chapter 11 Waveform Record
; the backlight goes on (in red)
goes on (in
MSO2000A/DS2000A User Guide
goes off
directly to
[1]
. As the