Rigol 2000 Series User Manual page 253

Chapter 13 Signal Source
introduction in "Parameter Setting Method".
2. Interpolation
Press Interp to turn on or off the interpolation mode between the points of the
waveform.
ON: the waveform editor connects two points using a straight line.

OFF: the waveform editor will keep a constant voltage level between the

two points and create a ladder-like waveform.
3. Zoom
Press Zoom to turn on or off the zoom function.
ON: the waveform editing window only displays the current point.

OFF: the waveform editing window displays all the initial points.

4. Current Point
Press Current to select the point to be edited. The range is from 1 to the initial
points. For the setting method, please refer to the introduction in "Parameter
Setting Method".
5. Voltage
Press Voltage to set the voltage of the current point. The range is from -2.5 V to
+2.5 V. For the setting method, please refer to the introduction in "Parameter
Setting Method".
MSO2000A/DS2000A User Guide
RIGOL
13-15