Making Iscsi Data Port Settings - Promise Technology VTrak M610i Product Manual

Making iSCSI Data Port Settings

The network settings for the iSCSI data ports are located under the Network
Management and are described below. For the iSCSI settings for the iSCSI data
ports, see "Managing iSCSI Connections" on page 167.
Making Automatic Settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight the iSCSI port in the list and press Enter.
3. Highlight NetMgmt iSCSI Port Settings and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Enable.
5. Highlight TCP Port Number, and press the backspace key to erase the
current value, then type the new value.
Use 1 to 65535. The default is 3260.
6. Highlight Jumbo Frame and press the spacebar to toggle between Enabled
and Disabled.
7. Press Ctrl-A to save your settings.
Making Manual Settings
1. From the Main Menu, highlight Network Management and press Enter.
2. Highlight the iSCSI port in the list and press Enter.
3. Highlight NetMgmt iSCSI Port Settings and press Enter.
4. Highlight DHCP and press the spacebar to toggle to Disabled.
5. Highlight each of the following and press the backspace key to erase the
current value, then type the new value.
• IP Address
• Subnet Mask
• Gateway IP Address
6. Highlight TCP Port Number, and press the backspace key to erase the
current value, then type the new value.
The default is 3260.
7. Highlight Jumbo Frame and press the spacebar to toggle between Enabled
and Disabled.
8. Press Ctrl-A to save your settings.
Chapter 5: Management with the CLU
163