Table of Contents
Advertisement
VTrak M610i, M310i, M210i Product Manual
Reported Event
Drive Interface Controller
Drive-interface controller
found
Drive-interface controller
is NOT found
Drive-interface
diagnostics has passed
Drive-interface
diagnostics has failed
Drive-interface controller
has generated a general/
data parity error.
Enclosure
Enclosure temperature is
above the threshold/
warning threshold
Enclosure temperature is
above the critical
threshold
Enclosure temperature is
within the normal range
Event Log
Event logging is enabled
Event logging is disabled Event logging has been disabled.
Event log buffer is cleared
in RAM
Event log buffer is cleared
in NVRAM
Event log buffer is cleared
in MDD
Host Interface Controller
Host-interface controller
has detected bus reset
Normal.
Restart the VTrak. See page 90. If this message
appears repeatedly, contact Technical Support. See
page 285.
Normal.
Restart the VTrak. See page 90. If this message
appears repeatedly, contact Technical Support. See
page 285.
Drive-to-controller parity error. If this message
appears repeatedly, contact Technical Support. See
page 285.
The VTrak is overheating. Check for airflow around
and through the VTrak, and verify that all fans are
working. Replace fans as needed. See page 205.
The VTrak is seriously overheating. Check for airflow
around and through the VTrak, and verify that all fans
are working. Replace fans as needed. See page 205.
Normal.
Event logging has been successfully enabled.
The event log was cleared.
The non-volatile RAM event log was cleared.
The MDD (disk drive) event log was cleared.
The initiator sent a reset command. If this message
appears repeatedly, contact Technical Support. See
page 285.
258
Corrective Action
Advertisement
Table of Contents
