Reception Features
Reference
p.20 "Transfer Request"
Transfer Result Report
This reports whether transmission to
the End Receivers was successful or not.
When the Transfer Station has trans-
ferred the message to all End Receiv-
ers, it sends the Transfer Result
Report back to the Requesting Party.
The machine prints the report if it
cannot be sent back to the Requesting
4
Party.
Preparation
You must program the fax number
of the Requesting Party in a Quick
Dial key or Speed Dial in the
Transfer Station. Also, the return
address of the machine needs to be
programmed beforehand. See
p.152 "Transfer Report".
Note
❒ You can set whether to print the
document image is printed on this
report with the User Parameters.
See p. 138 "User Parameters"
(switch 04, bit 7).
- Sending the Transfer Result
-
-
-
Report
This machine compares the fax num-
ber of the Requesting Party with the
Requesting Party's number pro-
grammed in a Quick Dial key or
Speed Dial, and if the last five digits
of the two numbers match, it sends
the Transfer Result report to the Re-
questing Party.
• Requesting Party's own number:
44-11-22233333
• Transfer Station's Quick Dial:
011-22233333
72
Remote Transfer
This feature allows same make or oth-
er make fax machines without the
Transfer Request function to perform
transfer requests to this machine.
Preparation
In order for this machine to per-
form this function, you need to
register the Remote ID, and the
Transfer Result Report return ad-
dress in Quick Dial keys or Speed
Dials. See p.148 "ID Codes"; p.63
"Quick Dial", Basic Features; and
p.71 "Speed Dial", Basic Features.
Limitation
❒ The Requesting Party's fax ma-
chine must be able to send out a
push signal.
❒ The Remote Transfer function only
works with the standard and op-
tional G3 line. NIC FAX unit (Op-
tion for Type1) is not supported.
Note
❒ You can select whether the ma-
chine accepts Remote Transfers or
not with the User Parameters. See
p.138 "User Parameters" (switch
11, bit 0).
How to make a Remote Transfer Request
(push signal)
This procedure describes how to
make a Transfer Request to this ma-
chine from the Requesting Party's
machine. Require the Requesting Par-
ty to perform the following proce-
dure.
Note
❒ To cancel the operation in progress,
press the { { { { q
q } } } } key twice.
q
q
A A A A
Place your original, and then se-
lect any scan settings you require.