Mitsubishi Electric FR-F820-04750 Instruction Manual page 78

Control circuit
Crimp the blade terminal.
Insert wires to a blade terminal, and check that the wires come out for about 0 to 0.5 mm from a
sleeve.
Check the condition of the blade terminal after crimping. Do not use a blade terminal of which
the crimping is inappropriate, or the face is damaged.
Fig. 2-30:
Blade terminals commercially available (as of February 2015)
Cable gauge (mm²)
1.25, 1.5
0.75 (for two wires)
Tab. 2-22:
A blade terminal with an insulation sleeve compatible with the MTW wire which has a thick wire
insulation.
Applicable for the terminal A1, B1, C1, A2, B2, C2.
Cable gauge (mm²)
0.3 to 0.75
Tab. 2-23:
Insert the wires into a socket
2 - 50
Wire
Sleeve
10 mm
Crimped wire end sleeves
With insulation sleeve
0.3 AI 0,5-10WH
0.5 AI 0,5-10WH
0.75 AI 0,75-10GY
1 AI 1-10RD
AI 1,5-10BK
AI-TWIN 2 × 0,75-10GY
Phoenix Contact Co., Ltd.
Blade terminal product number
NICHIFU Co.,Ltd
Damaged
Blade terminal model
Without insulation sleeve
⎯
⎯
A 0,75-10
A 1-10
A 1,5-10
⎯
Insulation cap product number
BT 0.75-11
Fig. 2-31:
Cable connection
Installation and wiring
Wires are not
Crumpled
inserted into the
tip
sleeve.
Crimping tool
For UL wire
⎯
AI 0,5-10WH-GB
AI 0,75-10GY-GB
CRIMPFOX 6
AI 1-10RD/1000GB
AI 1,5-10BK/1000GB
⎯
Crimping tool
product number
VC 0.75
Unstrand-
ed wires
I002396E
NH 69
I002398E