Tool; Connector; Cable Connection To Input/Output Connector - Mitsubishi Electric Melsec-F FX3GC Series User Manual

FX /FX /FX /FX /FX
3S 3G 3GC 3U 3UC
Built-in Positioning Functions
3.2.3

Tool

For tightening the terminal, use a commercially available small screwdriver
having a straight form that is not widened toward the end as shown right.
Note:
If the diameter of screwdriver grip is too small, tightening torque will not
be able to be achieved. To achieve the appropriate tightening torque
shown in the table on the previous page, use the following screwdriver or
appropriate replacement (grip diameter : approximately 25 mm (0.98")).
<Reference>
Manufacturer
Phoenix Contact
3.3

Connector

Connectors conforming to the requirements of the MIL C-83503 are used for the FX
unit along with some types of FX
3.3.1

Cable Connection To Input/Output Connector

Prepare the input/output cables while referring to the next Subsection.
Example : FX
3UC
PLC User's Manual - Positioning Control Edition
/FX Series input/output extension blocks.
2N 2NC
-32MT/D Main unit
3 Connection of Input/Output Lines and Tightening Torques
Model names
SZS 0.42.5
Input: X Output: Y
Input
X0
X1
X2
X3
X4
X5
X6
X7
COM COM
*1
*1: "•" means that the terminal is not used.
3.3 Connector
With
straight tip
0.4mm 2.5mm
(0.02") (0.1")
/FX Series main
3GC 3UC
Output
X10 Y0 Y10
X11 Y1 Y11
X12 Y2 Y12
X13 Y3 Y13
X14 Y4 Y14
X15 Y5 Y15
X16 Y6 Y16
X17 Y7 Y17
COM1 COM1
*1 *1 *1
B - 45
A
B
Apx.