Output Specifications; Fx 3S Series Main Unit (Transistor Output - Mitsubishi Electric Melsec-F FX3GC Series User Manual

FX /FX /FX /FX /FX
3S 3G 3GC 3U 3UC
Built-in Positioning Functions
2.5

Output Specifications

2.5.1 FX Series main unit (Transistor Output)
3S
This section describes the transistor output specifications of the FX
simultaneous turning-on rate is restricted for the main unit. For details on this restriction, refer to the following
manual.
For MELSERVO Series amplifiers, use a sink input/sink output type PLC.
External voltage
Resistance load
Maximum
load
Inductive load
Open-circuit leakage current
ON voltage
OFFON
Response
time
ONOFF
Circuit insulation
Indication of output motion
Pulse output terminals Y000 and Y001 are high-speed response output terminals.
To use the positioning instruction, adjust the load current of the NPN open collector to 10 to 100 mA (5 to 24 V DC).
Item
Operation voltage range
Operation current range
Output frequency
PLC User's Manual - Positioning Control Edition
Item
All outputs
All outputs
All outputs
All outputs
All outputs
Y000, Y001
Y002 to Y015 0.2 ms or less at 200 mA or more (at 24 V DC)
Y000, Y001
Y002 to Y015 0.2 ms or less at 200 mA or more (at 24 V DC)
All outputs
All outputs
Description
5 to 24 V DC
10 to 100 mA
100 kHz or less
Series main unit. Note that the
3S
Refer to the FX
Transistor output specifications
5 to 30 V DC
The total load current of resistance loads per common
terminal should be the following value or less.
- 1 point output common:0.5 A
- 4 points output common:0.8 A
The total of inductive loads per common terminal
should be the following value or less.
- 1 point output common:12 W/24 V DC
- 4 points output common:19.2 W/24 V DC
0.1 mA or less at 30 V DC
1.5 V or less
5 s or less at 10 mA or more (5 to 24 V DC)
5 s or less at 10 mA or more (5 to 24 V DC)
Photocoupler insulation
LED is lit when the photocoupler is driven.
2 Specifications
2.5 Output Specifications
Hardware Edition.
3S
Apx.
B - 29
A
B