Built-In Positioning Parameter Setting - Mitsubishi Electric Melsec-F FX3GC Series User Manual

FX /FX /FX /FX /FX
3S 3G 3GC 3U 3UC
Built-in Positioning Functions
11.4

Built-in Positioning Parameter Setting

Use GX Works2 or GX Developer to set the built-in positioning parameters.
The "Pulse" and "Frequency" set by the built-in positioning parameters in a positioning table can be changed
using the program, display module, or HMI.
11.4.1 Built-in Positioning Parameter Setting
Assuming that GX Works2 is used, this section describes how to set the built-in positioning parameters.
For details on GX Developer operating procedure, refer to GX Developer Operating Manual.
1
Open the "Parameter Setting" screen.
On the project view of the navigation window displayed, double-click "Parameter" and then "PLC
Parameter".
If the navigation window is not displayed, click "View" on the menu bar, and then click "Docking
Window", and then click "Navigation".
B - 154
PLC User's Manual - Positioning Control Edition
To change the set "number of pulses" or "frequency", refer to Subsection 11.4.2.
11 Batch Data Positioning Mode - TBL Instruction
11.4 Built-in Positioning Parameter Setting