Lenovo ThinkSystem DA240 Reference page 94

• FQXSPMA0002N: Configuration Error for [PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
This message is for the use case when an implementation has detected a Memory DIMM configuration
error has been corrected.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Memory
SNMP Trap ID: 41
CIM Prefix: PLAT CIM ID: 0126
User Action:
Complete the following steps:
1. This error could be caused by an uncorrectable memory error or failed memory test. Check the log
and service the event first. DIMMs disabled by other errors or actions could also lead to this event.
2. Verify that the DIMMs are installed in the correct population sequence.
3. Update UEFI firmware.
4. Replace the DIMM.
5. If the problem persists, collect the Service Data log.
6. Contact Lenovo Support.
• FQXSPMA0005N: Subsystem [MemoryElementName] has insufficient memory for operation.
This message is for the use case when an implementation has detected that the usable Memory is
insufficient for operation.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Memory
SNMP Trap ID: 41
CIM Prefix: PLAT CIM ID: 0132
User Action:
Complete the following steps:
1. Ensure one or more DIMMs have been installed in the compute node.
2. Resolve existing memory errors if they are present.
3. If no memory fault is recorded in the logs, verify that all DIMM connectors are enabled using the
Setup utility or the OneCLI utility.
4. Reseat all DIMMs ensuring that DIMMs are installed in the correct population sequence, according to
the service information for this product.
5. Clear the CMOS memory on the system board. Note that all firmware settings will revert to the
defaults.
6. Reflash UEFI firmware.
7. If the problem persists, collect the Service Data log.
8. Contact Lenovo Support.
• FQXSPMA0007L: Scrub Failure for [PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
90
ThinkSystem DA240 Enclosure and ThinkSystem SD630 V2 Compute Node Messages and Codes Reference