Lenovo ThinkSystem DA240 Reference page 208

Enclosure and compute node
Table of Contents

Advertisement

7. Contact Lenovo Support.
• FQXSFPU0033G: Processor has been disabled.
Severity: Warning
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or UEFI firmware update that applies to
this error.
2. Reboot the system.
3. If the problem persists, collect Service Data logs.
4. Contact Lenovo Support.
• FQXSFPU0034L: The TPM could not be initialized properly.
Severity: Error
User Action:
Complete the following steps:
1. Reboot the system. Reflash UEFI image.
2. If the problem persists, collect Service Data logs.
3. Contact Lenovo Support.
• FQXSFPU0035N: A 3-strike timeout has occurred on processor [arg1].
Severity: Fatal
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or UEFI firmware update that applies to
this error.
2. Reboot the system.
3. Check and reverse any recent changes to system settings or the Operating System.
4. If the problem persists, collect Service Data logs.
5. Contact Lenovo Support.
• FQXSFPU4033F: TPM Firmware recovery is in progress. Please DO NOT power off or reset system.
Severity: Warning
User Action:
Information only; no action is required.
Note: The system will not respond to power off signal (FQXSFPU4034I) while TPM firmware recovery in
progress.
• FQXSFPU4034I: TPM Firmware recovery is finished, rebooting system to take effect.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4035M: TPM Firmware recovery failed. TPM chip may be damaged.
Severity: Warning
204
ThinkSystem DA240 Enclosure and ThinkSystem SD630 V2 Compute Node Messages and Codes Reference

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinksystem sd630 v27d1j7d1k

Table of Contents