Table of Contents
Advertisement
User Action:
Information only; no action is required.
• FQXSPTR4000I: Management Controller [arg1] clock has been set from NTP server [arg2].
This message is for the use case where a Management Controller clock has been set from the Network
Time Protocol server.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0033
User Action:
Complete the following steps until the problem is solved:
1. Make sure that the certificate that you are importing is correct.
2. Try to import the certificate again.
• FQXSPTR4001I: Date and Time set by user [arg1]: Date=[arg2], Time-[arg3], DST Auto-adjust=
[arg4], Timezone=[arg5].
A user configured the Date and Time settings
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0079
User Action:
Information only; no action is required.
• FQXSPTR4002I: Synchronize time setting by user [arg1]: Mode=Sync with NTP Server,
NTPServerHost1=[arg2]:[arg3],NTPServerHost2=[arg4]:[arg5],NTPServerHost3=[arg6]:[arg7],
NTPServerHost4=[arg8]:[arg9],NTPUpdateFrequency=[arg10].
A user configured the Date and Time synchronize settings
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0085
User Action:
Information only; no action is required.
• FQXSPTR4003I: Synchronize time setting by user [arg1]: Mode=Sync with server clock.
A user configured the Date and Time synchronize settings
Severity: Info
Serviceable: No
Automatically notify Support: No
.
Chapter 3
XClarity Controller events
161
Advertisement
Table of Contents
