Lenovo ThinkSystem DA240 Reference page 87

UEFI deployment boot mode has been disabled
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0199
User Action:
Information only; no action is required.
• FQXSPFW0000N: The System [ComputerSystemElementName] encountered a POST Error.
This message is for the use case when an implementation has detected a Post Error.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0184
User Action:
Complete the following steps:
1. Original UEFI settings are still present. If a customer intends to continue using the original settings,
select Save Settings.
2. If the user did not intentionally trigger the reboots, check logs for probable cause. For example, if
there is a battery fault event, follow the steps to resolve that event.
3. Undo recent system changes (settings or devices added). Verify that the system boots. Then, re-
install options one at a time to locate the problem.
4. Check the Lenovo support site for an applicable service bulletin or firmware update that applies to
this error. Update UEFI firmware if applicable.
5. Remove and re-install the CMOS battery on the system board in 30 seconds to clear CMOS contents.
If it boots successfully, then restore the system settings.
6. If the problem persists, collect the Service Data log.
7. Contact Lenovo Support.
• FQXSPFW0001N: Firmware BIOS (ROM) corruption was detected on system
[ComputerSystemElementName] during POST.
Firmware BIOS (ROM) corruption was detected on the system during POST.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Other
SNMP Trap ID: 50
CIM Prefix: PLAT CIM ID: 0850
User Action:
Complete the following steps:
1. Try rebooting the system to see if the problem still exists.
2. If the problem exists, update the UEFI firmware.
.
Chapter 3 XClarity Controller events
83