Replacing Radiator Hose (Water Pipes); Replacing Fuel Hose; Replacing Engine Breather Hose; Replacing Brake Master Cylinder (Inner Parts) - Kubota RTV1140 CPX Operator's Manual

A When the coolant level drops due to evaporation, add
water only to keep the antifreeze mixing ratio less than
50%. In case of leakage, add antifreeze and water in
the specified mixing ratio before filling into the radiator.
BReplacing Radiator Hose (Water pipes)
Replace the hoses and clamps.
(See "Checking Radiator Hose and Clamp" in "EVERY
200 HOURS" in "PERIODIC SERVICE" section.)
BReplacing Fuel Hose
Consult your local KUBOTA Dealer for this service.
BReplacing Engine Breather Hose
Consult your local KUBOTA Dealer for this service.
BReplacing Brake Master Cylinder (Inner
Parts)
Consult your local KUBOTA Dealer for this service.
BReplacing Front Brake Seal
Consult your local KUBOTA Dealer for this service.
BReplacing Rear Brake Cylinder Seal
Consult your local KUBOTA Dealer for this service.
BReplacing Intake Air Line
Consult your local KUBOTA Dealer for this service.
BReplacing Remote Hydraulic Hose
Consult your local KUBOTA Dealer for this service.

EVERY 4 YEARS

BReplacing Brake Hose
Consult your local KUBOTA Dealer for this service.

SERVICE AS REQUIRED

BBleeding Fuel System
Air must be removed:
1. When the fuel filter or lines are removed.
2. When tank is completely empty.
3. After the vehicle has not been used for a long period
of time.
C Bleeding procedure is as follows:
1. Fill the fuel tank with fuel.
2. Pump the fuel pump lever. The fuel pump lever will
pump easily at first and with added resistance as air is
purged from the system.
(1) Fuel pump lever
3. Start the engine and run for about 30 seconds, and
then stop the engine.
PERIODIC SERVICE 73