Thin Ap; Basic Setting - TRENDnet TEW-730APO User Manual

TRENDnet User's Guide

Thin AP

Below describes the configuration settings when the TEW-730APO System Mode is set
to Thin AP mode. In this mode the access point can only be configured with a device set
on Virtual Access Control mode.
Configuration
1. Log into the management page (see
2. Your access point will prompt you for a user name and password.
3. Enter the default user name and password and then click Login.
Default User Name: admin
Default Password: admin
4. Click the System button on the left side and then System Settings.
5. Select Thin AP in the Device Mode drop down menu.
© Copyright 2015 TRENDnet. All Rights Reserved.
"Access the management page" on page 9).

Basic Setting

This page displays thin access points connected in the network.
1. Log into the management page (see
2. Click on Thin AP and Basic Settings.
General Settings
 Device Mode: Select the mode you would want the access point to operate on.
 Device Name: Enter a device name that can help distinguish each devices
IP Settings
 DHCP Client: Select this option to set the access point to obtain DHCP you're your
DHCP server.
 Static: Select this option to manually configure the access point's IP address.
o IP Address: Enter the IP address to assign
o Subnet Mask: Enter the subnet mask of the access point
o Gateway IP Address: Enter the gateway IP address
o DNS1-2: Enter the DNS IP address to assign on the access point.
TEW-730APO
"Access the management page" on page 9).
34