Table of Contents
Advertisement
Figure 47. Installing the smart card reader
Steps
1. Align and place the smart card reader on the palm-rest and keyboard assembly.
2. Replace the four screws (M2x2) that secure the smart card reader to the palm-rest and keyboard assembly.
3. Connect the clickpad flexible flat cable to the connector (TFAD1) on the clickpad.
Next steps
1. Install the
3-cell battery
2. Install the speakers.
3. Install the
base
cover.
4. Follow the procedure in
System board
Removing the system board
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
M.2 2230 solid-state
4. Remove the
3-cell battery
5. Remove the heat-sink.
About this task
The following image indicates the connectors on your system board.
80
Removing and installing Field Replaceable Units (FRUs)
or the
4-cell
battery, whichever is applicable.
After working inside your
Before working inside your
drive.
or the
4-cell
battery, whichever is applicable.
computer.
computer..
Advertisement
Table of Contents
