Required Tools; Fitting The Cable Harness; Fitting The Plc - Novexx Solutions 64 Series Technical Manual

08/10 Rev. 5.05-01

Required Tools

•
Philips screwdriver sizes 1 and 3
•
Screwdriver of medium size
•
Hex socket wrench WAF 4.5
•
Allen key 3 mm with ball head
•
Flat nose pliers

Fitting the Cable Harness

1. Switch off the device and disconnect the
power plug from the power outlet!
2. Remove the rear cover and the left front
housing.
How to? - see Service Manual 64-xx, topic
section Service Mechanics, chapter „Hou-
sing".
3. Disconnect the D-Sub cable harness.
Unscrew the ground strap from the printer
bottom.
4. Unscrew the D-Sub plug from the hou-
sing.
5. Fit the D-Sub plug of the new cable har-
ness to the housing (fig. 1).

Fitting the PLC

1. Remove the fixing screws of the power
supply.
How to? - see Service Manual 64-xx, topic
section Service Mechanics, chapter „Con-
nections and Electrics", „Power Supply".
Leave the angled plate (1) fixed to the po-
wer supply!
2. Disconnect the ground cable (2) and the
plug (3), to be able to move the power sup-
ply farther out of the printer housing.
3. Pull the power supply slightly out of the
printer housing as illustrated (fig. 2 and 3).
Continued overleaf.
TECHNICAL MANUAL
64-xx
1
2
3
4
Mounting the PLC