Controlling The Measurement; Parameters; Rst; Chapter 9.5, "Controlling The Measurement - R&S NRP Series User Manual

®
R&S NRPxxS(N)

Parameters:

<mode>
Example:
[SENSe<Sensor>:]AUXiliary <mode>
Enables the measurement of additional-measured values that are determined together
with the main-measured value.
Parameters:
<mode>

9.5 Controlling the measurement

The power sensor offers a bunch of possibilities to control the measurement:
●
Do you want to start the measurement immediately after the initiate command or
do you want to wait for a trigger event?
●
Do you want to start a single measurement cycle or a sequence of measurement
cycles?
User Manual 1177.5079.02 ─ 15

*RST:

"POWer:AVERage"
The following sequence of commands configures a peak trace
measurement:
*RST
SENSe:FUNCtion "XTIMe:POWer"
SENSe:FREQuency 1.0e9
SENSe:TRACe:POINts 500
SENS:TRAC:TIME 20e-3
TRIGger:SOURce INTernal
TRIGger:SLOPe POSitive
TRIGger:DTIMe 0.001
TRIGger:HYSTeresis 0.1
TRIGger:LEVel 30e-6
SENSe:TRACe:AVERage:COUNt 8
SENSe:TRACe:AVERage:STATe ON
CALCulate:FEED "POWer:PEAK:TRACe"
INITiate
FETCh?
NONE | MINMax | RNDMax
NONE
No additional values are measured.
MINMax
Minima and maxima of the trace are transmitted together with
the measured value.
Usually, extreme values are lost due to averaging the measured
values.
RNDMax
Randomly selected samples are transmitted. All evaluations use
these values instead of the average values.
*RST: NONE
Remote control commands
Controlling the measurement
73