Trace Mode - R&S NRP Series User Manual

®
R&S NRPxxS(N)
Number of
Nominal
Start
End
Number of Timeslots
Sets the number of simultaneously measured timeslots. Up to eight slots can be
selected.
Remote command:
[SENSe<Sensor>:][POWer:]TSLot[:AVG]:COUNt
Nominal Width
Sets the length of a timeslot in seconds.
Remote command:
[SENSe<Sensor>:][POWer:]TSLot[:AVG]:WIDTh
Start Exclude
Sets a time that is to be excluded at the beginning of the measurement period.
Remote command:
[SENSe<Sensor>:]TIMing:EXCLude:STARt
End Exclude
Sets a time that is to be excluded at the end of the measurement period.
Remote command:
[SENSe<Sensor>:]TIMing:EXCLude:STOP

6.4.4 Trace mode

Describes the parameters of the trace measurement.
Further information:
●
Chapter 9.7.4, "Trace
Detailed description of the trace measurement mode and its remote commands
Access: main dialog of the web user interface > navigation pane > "Trace"
User Manual 1177.5079.02 ─ 15
Timeslots..................................................................................................... 48
Width...............................................................................................................48
Exclude.................................................................................................................48
Exclude.................................................................................................................. 48
measurement",
Browser-based user interface
on page 98
Measurement modes
48