Trigger Settings - R&S NRP Series User Manual

®
R&S NRPxxS(N)
Auto Measurement Time
Available only if "Noise Content" is set under
Sets an upper limit for the settling time of the auto-averaging filter, thus limiting the
length of the filter.
Remote command:
[SENSe<Sensor>:]AVERage:COUNt:AUTO:MTIMe

6.5.3 Trigger settings

Describes the trigger parameters. You can define the conditions that have to be fulfilled
for a measurement to be triggered.
Further information:
●
Chapter 9.5.5, "Configuring the
●
Chapter 9.5, "Controlling the
Access: main dialog of the web user interface > navigation pane > "Trigger"
Trigger
Trigger
Trigger
Dropout......................................................................................................................... 53
Holdoff...........................................................................................................................53
Hysteresis..................................................................................................................... 53
Trigger Source
Groups the trigger source settings.
<Source> ← Trigger Source
Selects the trigger source. See
Remote command:
TRIGger:SOURce
<Slope> ← Trigger Source
Sets the polarity of the active slope of the trigger signal that is externally or internally
applied.
"Positive"
"Negative"
User Manual 1177.5079.02 ─ 15
Source...............................................................................................................52
└ <Source>........................................................................................................ 52
└ <Slope>...........................................................................................................52
Level................................................................................................................. 53
Delay.................................................................................................................53
The rising edge of the trigger signal is used for triggering.
The falling edge of the trigger signal is used for triggering.
"<Mode>"
trigger", on page 83
measurement", on page 73
Chapter 9.5.2.3, "Trigger
Browser-based user interface
on page 45.
sources", on page 76.
Settings
52