Preparing For The Measurement; Selecting The Reference Source; Selecting A Measurement Path; [Sense<Sensor>:]Range - R&S NRP Series User Manual

®
R&S NRPxxS(N)
Usage:

9.4 Preparing for the measurement

Before starting a measurement, you need to do the following:
● Selecting the reference
● Selecting a measurement
● Selecting a measurement
● Configuring the measured

9.4.1 Selecting the reference source

The ROSCillator subsystem contains commands for configuring the reference
source.
[SENSe<Sensor>:]ROSCillator:SOURce <source>
Sets the source of the reference oscillator. Refers typically to a precision, stabilized
time base.
Parameters:
<source>
Example:

9.4.2 Selecting a measurement path

The RANGe subsystem contains commands for selection of a measurement path.
Remote commands:
[SENSe<Sensor>:]RANGe
[SENSe<Sensor>:]RANGe:AUTO
[SENSe<Sensor>:]RANGe:CLEVel
[SENSe<Sensor>:]RANGe <range>
Sets the selected path as active measurement path.
Parameters:
<range>
User Manual 1177.5079.02 ─ 15
Event
source............................................................................... 70
path............................................................................... 70
mode............................................................................. 71
values........................................................................... 72
INTernal | EXTernal | HOST
INTernal
Internal precision oscillator
EXTernal | HOST
External signal supplied at the host interface connector.
*RST: If the sensor boots or reboots, the source is set to
INTernal. If the sensor is reset, the source setting is
kept unchanged.
ROSC:SOUR INT
................................................................................................70
......................................................................................71
.................................................................................... 71
The sensitivity of the paths differs.
Remote control commands
Preparing for the measurement
70